Holzstar FKS 315-2000 E, Руководство по эксплуатации

Страница: 8 / 34

8 FKS 315-2000 E | Version 1.11
Device description
General risks during internal transport
Devices may only be transported by authorized and qua-
lified persons. Act responsibly during transport and al-
ways consider the consequences. Refrain from daring
and risky actions.
Gradients and descents (e.g. driveways, ramps and the
like) are particularly dangerous. If such passages are
unavoidable, special caution is required.
Before starting the transport check the transport route for
possible danger points, unevenness and disturban-ces
as well as for sufficient strength and load capacity.
Danger points, unevenness and disturbance points must
be inspected before transport. The removal of danger
spots, disturbances and unevenness at the time of trans-
port by other employees leads to considerable dangers.
Careful planning of internal transport is therefore essen-
tial.
Transport with a forklift / pallet truck:
For shipping, the boxed unit is delivered on a pallet so
that it can be transported by forklift or pallet truck.
5.2 Packaging
All used packaging materials and packaging aids of the
panel saw are recyclable and must always be recycled.
Packing components made of cardboard are crushed to
waste paper collection.
The foils are made of polyethylene (PE) and the uphol-
stery parts made of polystyrene (PS). You can hand over
these substances to a recycling center or to the disposal
company responsible for you.
5.3 Storage
Thoroughly clean the panel saw in a dry, clean and frost-
free environment. Cover the machine with a protective
tarpaulin.
Ambient temperature range: -25 ° C to +55 ° C.
6 Device description
6.1 Machine
Illustrations in this manual may differ from the origi-
nal.
Fig. 6: Panel saw FKS 315-2000 E
1 Telescope stop
2 Workpiece stop
3 Sliding table
4 Sliding carriages
5 Saw blade protection with suction connection
6 Clamping device for workpiece
7 Cutting angle adjustment device
8 Suction hose with holder
9 Stop with fine adjustment and clamping lever
10 ON and OFF switch
11 Handwheel for setting the saw blade height
12 Screw for fine adjustment of the stop
13 Handwheel for fine adjustment of the inclination angle
14 Transport roller
Fig. 7: Sawing unit Auxiliary blade
U Separating knife 1 Adjusting screw Auxiliary saw blade
V Saw blade 2 Clamping screw Auxiliary saw blade
W Auxiliary blade 3 Height adjustment Auxiliary blade
WARNING: DANGER OF TIPPING
The device may be lifted unsecured by a maximum
of 2cm.
Employees must be outside the danger zone, the
reach of loads.
Warn employees and, if necessary, advise employ-
ees of the hazard.