Holzstar FKS 315-2000 E, Руководство по эксплуатации

Страница: 22 / 34

22 FKS 315-2000 E | Version 1.11
Troubleshooting
11 Troubleshooting
Fault Possible cause Solution
Engine does not start No mains voltage
Connection cable defective
Have the power connection checked
by qualified personnel.
Engine is running, saw blade is not
turning Drive belt torn Replace the drive belt
Engine is getting hot 1. Engine short circuit
2. Overload of the engine
1. Disconnect the power plug and
have the machine repaired by qua-
lified personnel.
2. Check that the saw blade is
suitable for the material to be cut.
Check if the saw blade is still suffi-
ciently sharp
Take a break from work and let the
engine cool down.
Saw blade speed too low 1. Engine defective
2. too low mains voltage
1. Have the engine checked by quali-
fied personnel.
2. Have the mains voltage checked
by qualified personnel
Saw blade rotates unevenly under
load Drive belt not sufficiently tensioned Check the belt tension.
Saw blade does not start or stops un-
der load Drive belt not sufficiently tensioned Check the belt tension.
Saw vibrates, saw blade strikes 1. Saw blade does not match the
specification
2. Saw blade not sufficiently secured
3. Saw blade defective
1. Check on the basis of the specifi-
cations in the technical data
whether the saw blade is suitable
for installation.
2. Tighten the fixing screw.
3. Check the saw blade for mechani-
cal damage and replace it if neces-
sary.
No clean 45 ° or 90 ° cuts 1. Stops not aligned correctly
2. Angle display not set correctly
1. Check the saw blade with stan-
dard angle and align the stops.
2. Check saw blade with standard
angle and adjust angle display.
Workpiece is knocked back by the
saw blade. 1. Stops not aligned correctly
2. Disconnect blade not aligned with
saw blade
3. Defective saw blade
1. Align the stops.
2. Align the cutting blade with the
saw blade.
3. Replace the saw blade.
Braking time of the saw is longer
than 10 seconds. Loose belt Tighten belt or replace if worn