Holzstar FKS 315-2000 E, Руководство по эксплуатации

Страница: 15 / 34

Operation of the Panel saw
FKS 315-2000 E | Version 1.11 15
ON-OFF switch
Fig. 31: ON-OFF switch FKS 315-2000 E
8.1 Sawing with the sliding table
Fig. 32: Sawing operation with sliding carriage
Step 1: Mount the sliding table on the sliding carriage.
Step 2: Move the sliding table to the end of the sliding
carriage.
Fig. 33: Adjust position lever
Step 3: Insert the stop in the front guide holes, align and
clamp with the clamping lever.
Step 4: Adjust the side stop to the desired cutting width.
Step 5: Place the workpiece on the saw table, mount the
quick release and clamp the workpiece.
Step 6: Switch on the suction device, switch on the saw
and carry out the sawing process.
8.2 Sawing with the saw table
Step 1: Slide the sliding table out of the sawing area and
clamp the sliding carriage in a stationary posi-
tion.
Step 2: Adjust the stop to the desired cutting width.
Step 3: Place the workpiece on the saw table.
Fig. 34: Sawing operation with the saw table
Step 4: Switch on the suction device, switch on the saw
and carry out the sawing process.
8.3 Stop positions
If the stopper is mounted in the required position, you
can cut large workpieces with the sliding table saw.
Fig. 35: Stop in front position for large workpieces
If the stop is mounted in the rear position, smaller work-
pieces can be cut with the sliding table saw.
Fig. 36: Stop in rear position for smaller workpieces
With the angle stop Miter cuts can be made with the sli-
ding table saw.
ATTENTION!
If the workpiece protrudes more than 1200 mm to the left
of the saw blade, the stop guide must be extended.