Holzstar FKS 315-2000 E, Руководство по эксплуатации

Страница: 19 / 34

Care, Maintenance and Repair
FKS 315-2000 E | Version 1.11 19
Step 8: Check that a correctly dimensioned cutting knife
and a suitable auxiliary saw blade are fitted and
aligned with the saw blade.
Step 9: Mount the saw blade guard.
9.2.2Change of auxiliary saw blade
Step 1: Disconnect the power plug from the socket.
Step 2: Set the saw blade inclination angle to 0 ° (90 ° to
the saw table) and move the saw blade up as far
as possible.
Step 3: Push the sliding carriage to the right as far as
possible, unscrew the two M6x12 screws and re-
move the saw blade guard.
Step 4: Remove the insert at the table.
Fig. 46: Unscrew the auxiliary saw blade
Step 5: Insert the shaft pin into the hole on the inside of
the auxiliary saw blade flange to lock the auxili-
ary saw blade and unscrew the auxiliary saw
blade nut with the wrench.
Fig. 47: Align auxiliary saw blade
Step 6: Loosen the clamping screw A. The lateral adjust-
ment is made with the adjusting screw B, the
height adjustment with the adjustment screw C.
Adjust the auxiliary saw blade so that it is in line
with the main saw blade. Then tighten the clam-
ping screw A again.
9.2.3Change of cutting knife
Fig. 48: Align cutter
Step 1: Disconnect the power plug from the socket.
Step 2: Set the saw blade inclination angle to 0 ° (90 ° to
the saw table) and move the saw blade up as far
as possible.
Step 3: Push the sliding carriage to the right as far as
possible, unscrew the two M6x12 screws and re-
move the saw blade guard.
Step 4: Release the fastening bolt for the separating
knife and remove the separating knife.
Step 5: Insert the new cutting knife and loosely screw it
on.
Wear safety gloves!
ATTENTION!
The auxiliary saw blade measures 90 x 20 x 3 mm
(outer diameter, inner diameter, thickness)
ATTENTION!
Each time you change the blade thickness, you must
fit an appropriately dimensioned cutting blade and a
suitable auxiliary saw blade.
ATTENTION!
The cutting knife is partially structured. The structu-
red area must be below the saw table.
The fastening bolt is inserted in a slot so that the hori-
zontal distance to the saw blade can be varied.