Hoggi Bingo OT, Руководство пользователя

Страница: 6 / 41

5
The pushchair is only intended to carry one child at a time.
The maximum load for the BINGO street frame is 50 kg.
The maximum load for the BINGO seat unit is 35 kg.
Accessories and add-ons reduce the maximum load proportionately.
Attention!
We recommend that, wherever and whenever possible, users transfer to the seats installed
in the motor vehicle and use the corresponding vehicle restraint systems, because this is
the only way to ensure optimum protection of the passengers in case of an accident.
Your BINGO Rehab Pushchair was successfully tested in accordance with ANSI/RESNA
WC/19 and ISO 7176/19 (Crash Test).
It is, however, possible to use your BINGO Rehab Pushchair as a seat in a motor vehicle, if
our “Tie down Kit” (article 3201-7300) as well as appropriate restraint systems are used.
This Rehab Pushchair is equipped with back angle and seat tilt adjustment. Before starting
you must tilt the backrest until the lock pin (A) locks into the hole (B) in the back plate.
Tighten the lever (C) well after this adjustment. Using the seat tilt adjustment you must
bring the backrest into almost upright position (max. 20°). Observe the specifications
under 4.6 and 4.13 in this user manual.
Caution!
Excess strap ends on accessories may be trapped between the two parts of the seat
mounting interface and prevent a full engagement of the lock pin. In such a case the seat
could fall off the mobility base. Shorten excess strap ends on accessories so that they can
not be trapped.
Check by pulling the seat sharply forward that the seat unit is properly engaged. Check
that the lock pin is completely engaged. Push in completely, if necessary.
Whenever you change any settings on the BINGO rehab pushchair, make sure that you
firmly tighten any screws that have been loosened.