10 of 22
JAN 2022 REV. C
EAZ0080V72A
6.0
Lowering the Jack Beam
1. To lower the Jack Beam, first raise the Jack Beam up off the mechanical safety
lock.
2. Disengage the safety lock by lifting and holding the Safety Release Handle.
3.
Press the “RELEASE" handle down on the pump to release pressure allowing the
jacking Beam to lower to its full down position.
4. Once Jack Beam is completely collapsed, release the safety and lowering
handles.
5. If lowering from the 2
nd
or 3
rd
lock position to the 1
st
lock position, repeat steps 1
to 4. You may release the safety handle once the 2
nd
safety has passed.
6. Lower the Jack Beam onto each safety (Note: there are three safety positions to
allow for multiple working heights).
NOTE:
The Safety Release handle is gravity
returned to “reset” the safety.
After reading these instructions, get familiar with the controls by running the
Jack Beam through a few cycles before loading vehicle on lift.
7.0
Storage Position of Jack Beam
In order to allow for adequate vehicle drive-on clearance,
1. When not in use, store Jack Beams towards the center of the lift.
2. Ensure lift is fully collapsed.
3. Remove lifting pads if additional clearance is required
8.0
Positioning of Vehicle on Jack Beam
The WHEELFREE
®
jack system has a low profile design, however; this may not be
suited for all vehicles.
Cautionary steps to consider before driving a vehicle over a rolling jack onto or off of a
lift.
Inspect the underside of the vehicle for low hanging obstructions.
Inspect the vehicle for points of interference
Position rear rolling jack Beam forward from the rear of the lift.
Jack pads and extensions must be removed from the jack.
Make certain the jack is in is fully lowered position
Floor areas must be clear from objects that may be in the path when lowering the
lift and/or jack Beam
Air supply must be maintained
