scissor jacks
model no’s:
57M.V2, 58M
Thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. saFETY
9
ensure that the jack is in good working order. Take action for immediate repair or replacement of damaged parts.
Use genuine parts only. The use of unauthorised parts may be dangerous and will invalidate the warranty.
9
locate the jack in a suitable, well lit work area.
9
Keep work area clean and tidy and free from unrelated materials.
9
Use jack on level and solid ground, preferably concrete.
Avoid tarmacadam as jack may sink in
.
9
ensure the vehicle handbrake is engaged, engine/motor is switched off and transmission is in 1st or reverse
gear (or park for automatics).
9
ensure minimum distance of 0.5m between vehicle and static objects such as doors, walls, etc., to allow for
vehicle tilting.
9
only place jack under those lifting points recommended by the vehicle manufacturer
(see vehicle handbook).
9
Check the lifting point is stable and centred on the jack saddle.
9
ensure there are no passengers in the vehicle.
9
Place chocks under wheels of vehicle
.
9
ensure all non-essential persons keep a safe distance whilst the jack is in use.
9
Use suitable capacity axle stands under the vehicle before proceeding with any task.
9
ensure there are no persons or obstructions beneath the vehicle before lowering.
▲
DANGER:
Use the jack for lifting only,
NOT
for supporting the lifted load.
8
Do NoT
operate the jack if damaged.
8
Do NoT
work under the vehicle until appropriately rated axle stands have been correctly positioned.
8
Do NoT
allow untrained persons to operate the jack.
8
Do NoT
use the jack for purposes other than that for which it is designed.
8
Do NoT
exceed the rated capacity of the jack.
8
Do NoT
jack vehicle if there is a risk of spillage of fuel, battery acid, or other dangerous substance.
8
Do NoT
allow the vehicle to move while supported by the jack.
9
When not in use store jack, fully lowered, in a safe, dry, childproof area.
WarNiNG!
It is
very dangerous
to go under a vehicle which is supported by a jack
even
if additional supports are
used.
DO NOT
go under a vehicle unless it is supported by adequately rated axle stands.
iMPorTaNT!
ensure that you can see the saddle and jacking point throughout the jacking operation in case
there is any relative movement.
2.
i
iNTroDucTioN
manufactured to German Gs/TUV standards. Fine rolled threading and precision made thrust bearing for long life and smooth operation. Curved
base plate allows for radial movement when lifting vehicle.
3. sPEciFicaTioN
model no ....................................................................57m.V2
max. height ................................................................ 330mm
min. height ................................................................... 85mm
Closed length ............................................................. 365mm
Capacity ....................................................... 1000kg (1tonne)
Weight ......................................................................... 2.15kg
Refer to
instruction
manual
Wear safety
footwear
Original Language Version
© Jack sealey limited
model no ......................................................................... 58m
max. height ................................................................ 375mm
min. height ................................................................. 100mm
Closed length ............................................................. 405mm
Capacity .................................................... 1500kg (1.5tonne)
Weight ......................................................................... 2.56kg
57m.V2, 58m| Issue:5 (H,1,F) 30/05/18
Apply
Chock
Wheels
Never
exceed
X2
