6 of 22
JAN 2022 REV. C
EAZ0080V72A
2.0
Shipping Contents
The jacking Beam is fully assembled and packaged to protect it from any damage that
may occur during shipping. Included are the following components:
Jacking Beam assembly, including:
-
Jacking Beam Assembly
-
Lifting Arms
-
Roller Adapters
-
Air/Hydraulic Pump
Stack Pads, Adapters & Holder
Installation & Operation Manual
3.0
Safety Instructions
Never allow unauthorized or untrained persons to operate the Jack Beam.
Thoroughly train all employees in the use and care of the Jack Beam.
Allow 12” minimum clearance between vehicle and nearest overhead obstruction
before raising vehicle above runways. This number is dependent on the number
and size of stack adapters used. For each stack adapter, minus the length of
each from 12”. Failure to comply can result in vehicle damage and/or personal
injury.
To avoid personal injury and/or property damage, the Jack Beam must only be
operated by trained personnel.
Never overload the Jack Beam. Capacity of Jack Beam is stated on nameplate,
DO NOT
exceed.
Observe and avoid any pinch point areas of the Jack Beam.
Never operate a Jack Beam that is not in proper working order or in a manner not
recommended by the vehicle or Jack Beam manufacturer.
Always ensure that the mechanical safety is engaged whenever a vehicle is
supported by the Jack Beam.
Do not use different length stack adapter on each arm. Stack adapter must be
used in pairs.
Load evenly; do not place weight on one side of the jack.
