Hochiki FirePro Xtinguish, Инструкция по установке и эксплуатации

Страница: 6 / 113

Page 6 of 113
FirePro Xtinguish I&O Manual V1.05 UL
1 Introduction
This manual is written for those who are installing a FirePro Xtinguish condensed aerosol fire extinguishing system
for total flooding applications.
Hochiki America Corporation
assumes no responsibility for the application of any system other than those
addressed in this manual.
The technical data contained in this manual is strictly limited for information only.
Hochiki America
Corporation
believes this data to be accurate, but it is published and presented without any warranty or
guarantee whatsoever. Hochiki America Corporation disclaims any liability for any use that may be made of
the data and information contained herein by any and all other parties.
IMPORTANT NOTICES
Warranty Disclaimer
Hochiki America Corporation makes no guarantees of any kind, either express or implied, including but
not limited to warranties of the FirePro Xtinguish products for their fitness for a particular purpose.
Limitation of Liability
In no event, regardless of cause, shall Hochiki America Corporation be liable for any indirect, special,
incidental, punitive, or consequential damages of any kind, even if advised of the possibility of such
damages.
Any questions concerning the information presented in this manual should be addressed to:
Hochiki America Corporation
7051 Village Drive Suite 100
Buena Park, CA 90621
United States of America
Phone: 1-(714)-522-2246, Fax: 1-(714)-522-2268
E-mail: technicalsupport@hochiki.com
Note: this manual quotes directly from NFPA standards, including NFPA 2010
(2015 Edition) and NFPA 72 (2010 Edition). These standards, along with other
national and local codes and requirements, must be carefully followed at all
times during all phases of system design, installation, operation and
maintenance.
The FirePro Xtinguish and HCVR-3/eLAN systems must be
installed, serviced and maintained only by Hochiki America
factory-trained and authorized technicians.