Hochiki FirePro Xtinguish, Инструкция по установке и эксплуатации

Страница: 57 / 113

Page 57 of 113
FirePro Xtinguish I&O Manual V1.05 UL
13 Total Flooding System Commissioning
13.1 General
The completed
FirePro Xtinguish
condensed aerosol system shall be reviewed and verified by
qualified personnel to meet the approval of the authority having jurisdiction.
All
FirePro Xtinguish
condensed aerosol system components and auxiliary devices used shall be
UL-listed. Non-listed equipment shall not be used under any circumstances.
13.2 Installation Acceptance
13.2.1 Basic Checks
Confirm that the protected enclosure is in conformance with the construction documents.
The
FirePro Xtinguish
condensed aerosol generators shall be securely fastened to prevent
unacceptable vertical or lateral movement during discharge.
The
FirePro Xtinguish
condensed aerosol generators shall be oriented in such a manner that
optimum agent dispersal can be effected.
The
FirePro Xtinguish
condensed aerosol generator stream shall not directly impinge on areas
where personnel may be located.
The
FirePro Xtinguish
condensed aerosol stream shall not directly impinge on any loose objects
or shelves, cabinet tops, or similar surfaces where loose objects could be present and become
missiles.
An adequate number/quantity of
FirePro Xtinguish
condensed aerosol generators to produce the
desired specified design application density shall be provided.
The actual room volumes shall be checked against those indicated on the system drawings to
ensure the proper quantity of
FirePro Xtinguish
condensed aerosol agent.
Fan coast down (inertia) and damper closure time shall be taken into consideration.
13.2.2 Review Enclosure Integrity
All
FirePro Xtinguish
condensed aerosol total flooding systems shall have the enclosure examined
and tested to locate and then effectively seal any air leaks that could result in a failure of the enclosure
to hold the specified
FirePro Xtinguish
condensed aerosol design application density for the
specified holding period.
13.2.3 Review Electrical Components
13.2.3.2 Wiring
All wiring systems shall be installed in compliance with local codes and the system drawings.
Alternating current (ac) and direct current (dc) wiring shall not be combined in a common conduit or
raceway.
13.2.3.3 Field Circuits
All field circuits shall be free of ground faults and short circuits.
Where field circuitry is being measured, all devices such as smoke detectors and notification
appliances shall be removed and jumpers installed to prevent the possibility of damage within these
devices. The devices shall be replaced after measuring.