Hochiki FirePro Xtinguish, Инструкция по установке и эксплуатации

Страница: 65 / 113

Page 65 of 113
FirePro Xtinguish I&O Manual V1.05 UL
15.5 Removing the FirePro Xtinguish Condensed Aerosol Generators
When the
FirePro Xtinguish
condensed aerosol generators have to be disconnected and removed,
the following steps shall be accomplished:
- Remove power from the fire detection system and ensure that it cannot be switched
on;
- Disconnect the power wires from the
FirePro Xtinguish
condensed aerosol
generators and ensure that they cannot be connected;
- Ensure that you are standing firmly and comply with the rules for working at height
(Working Conditions Act);
- Remove the
FirePro Xtinguish
condensed aerosol generators by unscrewing the
bolts and nuts holding them;
- Carefully remove the
FirePro Xtinguish
condensed aerosol generator from the
brackets and place it on a stable surface;
- After removing the
FirePro Xtinguish
condensed aerosol generators, put the fire
detection and alarm installation back into operation in accordance with the guidance
of the Authority Having Jurisdiction.
- If the
FirePro Xtinguish
condensed aerosol generators have been activated and
are still warm, wear heat-resistant gloves.
15.6 Waste and Environment
After activation the
FirePro Xtinguish
condensed aerosol generators may be disposed of as normal
waste after dismantling.
If a condensed aerosol generator has been removed from service
but it has not been activated and
it still contains the solid aerosol-forming compound FPC
, the generator must be returned to Hochiki
America Corporation for proper disposal.