Dual rate/ exponential (exp.)
Dual rate
changes the servo travel for a control surface on RIC aircraft (Ailerons, Elevator
and Rudder). Dual rate consists of Low rates and High rates. Low rates make the aircraft
less responsive (i.e. easier to control), and High rates make the aircraft more responsive
(i.e. harder to control). Dual rates are controlled by a selected switch (S1 to S8).
Exponential
is a radio function that will allow to change the control response of the control
sticks from being a linear response to exponential (non-linear) response. Exponential is
programmed such that very little servo response is provided when the control sticks are
near centered, or neutral. As the sticks are moved farther from the neutral point, more servo
response is generated at a rate greater than a straight linear response, allowing for quick and
precise maneuvers. Exponential values are available from -100% to + 100%.
Exponential and rate functions are available for channels CH1, CH2, CH4 and any switch
(S1 to SB) can be assigned to turn these functions ON and OFF.
Setup:
1. In main Menu, Press the Roller button to select "Dual rate/exp".
===Hain menu===
Servo setup
+Dual rate/exp.
Throttle curve
Throttle cut
Mixes
Range test
2. Press the Roller button to select Channel / Switch / Rate
I
Exp .
3. Move the Roller button left or right to select value.
=oual rate/exp.=
Pos
=
Pos 0
+Chl
Sw
=
Swl
Rate
100
Exp
0
//
/
4. Press and hold the wheel to save and exit , or press the cancel key to exit without saving.
Throttle curve
This function enables the user to adjust the ratio between stick and throttle response using
linear or nonlinear curves.
This is useful to change how the throttle reacts at different stick positions. The 5 points (L, 1, 2, 3,
H) of throttle curve can be adjusted from 0% to 100%. The horizontal dotted line displays in real
time the throttle stick position. The vertical dotted line displays in real time the position of the
throttle output after the throttle curve function has been applied. For example, having a smaller
throttle change when the stick is between 0-25%, then a larger throttle change between 25% and
100%. If your model's throttle is not linear, it is possible to use this function to create a more linear
movement.
.. •••••••••7x
1a
=
ID CHANNEL TRANSMITTER
8
�
�
'"""'
I
DICITALPRDPDRTIDNAL PRDCRAMMABLE
�I
•--=:: �
"-'
.,. �
�
J
RADIDCDNTADL SYSTEM
��®
Содержание ORX TX10i
Страница 1: ...21cm...
