Hobby King ORX TX10i, Инструкция по эксплуатации

Страница: 13 / 24

• Reset Switch-Turn the Roller Button to reset the switch 1 to 8 or None to position up, middle
or down.
• Press and hold the Roller button to save and exit, or press the cancel key to exit without saving.
Down and up Mode:
• Timer State-Turn the Roller button to select "Stop" or "Run". If "Run"is selected, the timer is
counting up.
• Reset - Press and hold the cancel key to reset the timer if needed, then press the Roller button.
• Set up -Turn the Roller button to set the time in min. and sec.
• Enable Switch-Turn the Roller Button to enable the switch 1 to 8 or None to position up, middle
or down.
• Reset Switch -Turn the Roller Button to reset the switch 1 to 8 or None to position up, middle or
down.
• Press and hold the Roller button to save and exit, or press the cancel key to exit without saving.
Telemetry
Choose sensors
The main screen can display the value of up to 3 sensors. This function is used to select which
sensors to display.
Setup:
1 . Press the wheel to select a slot 1, 2 or 3. Any sensors that are connected will automatically
populate this list.
2. Use the wheel to select the desired sensor.
3. Press and hold the wheel to save and exit, or press the cancel key to exit without saving.
Setup sensors
Telemetry
+Choose sensors
Setup sensors
This function is used to setup any sensors connected to the receiver. For example, to set the
higher and lower voltage alarm value, press the wheel to choose the sensor you want
and set the settings. Press and hold the wheel to save and exit, or press the cancel key to exit
without saving .
.. •••••••••7x 1a =
ID CHANNEL TRANSMITTER
13
�
� '"""'
I
DICITALPRDPDRTIDNAL PRDCRAMMABLE
�I
•--=:: �
"-' .,. � � J RADIDCDNTADL SYSTEM
��®