Hobby King ORX TX10i, Инструкция по эксплуатации

Страница: 17 / 24

Model Reset:
Resets a model to factory default settings.
1 . Use the wheel to select a memory slot for the model.
2. Press the wheel to select and then move the wheel to select yes and press the wheel again.
3. If needed press the cancel key to exit without saving.
Model copy:
Model reset
+Model 01
Model-01
"OK" to reset
Copies a model from one memory slot to another.
1 . Use the wheel to select a model to copy and press the wheel.
2. Use the wheel to select a memory slot to copy to.
3. Press and hold the wheel and then move the wheel to select yes.
4. If needed press the cancel key to exit without saving.
Flaps:
Model copy
Model 01
�
Model-01
Copy to
+Model 02
�....,__
Model-02
�
"MENU" to copy
Flaps increase lift at lower airspeeds by increasing the camber of the wing or, in some cases,
increasing the camber and surface area of the wing. This is quite useful during landing and take off.
If your model has flaps this function will set the [UP] and [DOWN] positions for the flaps. The flaps
can also be controlled by a switch, knob or logic gate. This function can also mix flap with aileron
movements.
Setup:
1. Use the wheel to enable the flaps function and press the wheel.
2. If needed use the wheel to set a switch and press the wheel.
3. Use the wheel to set the flap position and press the wheel.
4. Use the wheel to set the Elevon position.
5. Press and hold the wheel to save and exit, or press the cancel key to exit without saving.
Flaps
+Disabled
Flaps
+Single Flap
Sw
=
Disabled
Flap Pos 0= 0%
Ele Pos 0= 0%
FLP>ELE Pos 0= 0%
Flaps
+Dual Flaps
Sw
=
Disabled
Flap Pos 0= 0%
Flap2 Pos 0= 0%
Ele Pos 0= 0%
FLP>ELE Pos 0= 0%
.. •••••••••7x 1a =
ID CHANNEL TRANSMITTER
17
�
� '"""'
I
DICITALPRDPDRTIDNAL PRDCRAMMABLE
�I
•--=:: �
"-' .,. � � J RADIDCDNTADL SYSTEM
��®