Hobby King ORX TX10i, Инструкция по эксплуатации

Страница: 19 / 24

•Go to Flaperon section.
• Sw: - enable and assign available switch to turn flaperon On and Off (Sw 1 .. Sw8).
• A djust position of ailerons in Flaperon mode setting percentage (-100%~+100%).
• Positive percentage moves aileron in "flaps" position in one direction, while negative percentage
moves them in opposite direction. You should use negative or positive values depending on your model
setup. Percentage of the flaps is taken from the aileron servo travel set in Dual Ail section. For example if
Ail is set to travel 30 mm, ootting flaps to 20% will make aileron move 6mm when Flaperon function is ON.
Bind:
Aileron
+Single Ai 1
Aileron
+Dual Ai 1
Ail Neg100% Pos100%
Ai 12 Neg10m Pos10m
Flaperon
=
Sw
=
Disabled
Pos 0= 0%
1. Initiate binding procedure on your receiver (depends on the receiver used - bind plug, button,
auto-bind. To see how to initiate binding on the receiver please refer to the receiver manual).
2. Press and hold the binding key and turn on the transmitter. (Or, turn on the transmitter, press
and hold the wheel to enter the main menu to select model setup, then choose the bind menu to
enter binding mode).
3. The system will display "RX Binding .. ". After successfully binding, the transmitter will automatically
exit this binding menu.
4. If your receiver uses a bind plug for binding make sure you remove it after binding procedure.
Please also read the "NOTICE" section of Binding Procedure on P.6
RX Binding ..
Helicopter
Pitch curve
The pitch curve describes the non-linear relationship between the pitch (throttle) stick
movement and the collective pitch angle of the main rotor blades of the helicopter.
Pitch curve can be used to smooth out or alter the rotor pitch over the stick's range of movement.
For example if more reaction is needed through a certain range of the sticks movement then this
can be done by altering pitch curve.
Setup:
1. Press the wheel to change point values on the pitch curve.
2. Move the wheel left or right to change the point's value (position) on the graph.
3. Press and hold the wheel to save and exit, or press the cancel key to exit without saving.
r��i(ffi
L 1 2 3 H
.. •••••••••7x 1a =
ID CHANNEL TRANSMITTER
19
�
� '"""'
I
DICITALPRDPDRTIDNALPRDCRAMMABLE
�I
•--=:: �
"-' .,. � � J RADIDCDNTADLSYSTEM
��®