Hobby King ORX TX10i, Инструкция по эксплуатации

Страница: 20 / 24

Model setup
Swashplate mix
Adjust the motion range of the three inputs(aileron, elevator, pitch) to achieve the desired
maneuverability. Refer to your model's manual to ensure the best results.
This function is used to edit the pre-programmed mix control of the helicopter's aileron, elevator
and pitch.
Use the wheel to change the aileron, elevator and pitch values.
Setup:
1. Use the wheel to change the aileron value, then press the wheel.
2. Use the wheel to change the elevator value, then press the wheel.
3. Use the wheel to change the pitch value.
4. Press and hold the wheel to save and exit, or press the cancel key to exit without saving.
Gyroscope
This function is used for adjusting the gyrds sensitivity.
If the sensitivity is too high the helicopter will oscillate ( tail moving from side to side) and if the
sensitivity is too low the helicopter will be sluggish and unresponsive.
Setup:
1. Use the wheel to assign a switch or toggle to ON (always ON) , then press the wheel.
2. Use the wheel to change the position value.
3. Press and hold the wheel to save and exit, or press the cancel key to exit without saving.
Multi-copter
Mode
Gyroscope
+Sw
=
Disabled
Value
=
Pos 0
=
50r
■
The function can store up to 3 different modes which can be activated using a switch.
Setup:
1. Use the wheel to assign a switch or toggle to ON (always ON), then press the wheel.
2. If needed use the wheel to change the position value.
3. Press and hold the wheel to save and exit, or press the cancel key to exit without saving.
Mode
+Sw
=
Disabled
Value
=
Pos 0
=
1500
•••••••••••7x 1a =
ID CHANNEL TRANSMITTER
20
�
� '"""'
I
DICITALPRDPDRTIDNAL PRDCRAMMABLE
�I
•--=:: �
"-' .,. � � J RADIDCDNTADL SYSTEM
��®