Fig.8
Fig.9
Rys.10
9. Fitting the central covers
Take the front(22) and rear (23) covers and position them on the
main post(8) ,Fig.8.Now use the screws(15) and (68) to attach
them to the post .
10. Fitting the focus bar side covers to the foot bars
Next fit the footrest covers(66 & 67) with the bottom of the joints
on the left side,Fig.8. Use screws(68) to screw them together .
Then do the same with the other covers(66&67) on the right-hand
side .
11. Fitting the handlebar
Take the handlebar (4) ,remove screws(20),position the ends of the handlebar
on the plate at the top of the main post(8),Fig.9. Refit the screws (20) removed
previously .
12. Fitting the electronic monitor.-attaching the feed
back cable
Take hold of the cable(36),which is sticking up out of the main
post(8),Fig.10,and plug it into the connector (36a) at the back of
the electronic unit (1),as shown in Fig.10
13. Fitting the hand-grip cable
Take hold of the Hand-grip connectors (54a&55a) located at the
back of the monitor(1),as shown in Fig.10.
14. Attaching the monitor
Release screws(2),Fig .10 ,at the back of the monitor .
Next,slide the front of the monitor onto the plate on top of the main
post(8) in the direction of the arrow ,FIG.10.,push the cables down
into the main post marking sure not the pinch any of the
cables.Replace the screws(2) removed previously .
ATTENTION:
It is important to retighten all of the screws involved in assembling
the machine after approximately a week of use as this will prevent
any strange noises and possible damage .
