Hitachi 3080 G2, Справочник по аппаратуре

Страница: 120 / 129

Ite
m
Labels Ports Connections
3 Storage or FC switch
4 Storage or FC switch
5 0 Customer facing management network
6 1 Private management network
5. If cables are not labeled, label them before removing them from the
server.
6. Remove all cables from the server, and remove the server from the rack.
7. Remove the rail mounts from the old server, and install them on the new
server.
8. Remove the battery from the old server, and install it in the new server.
9. Remove the bezel from the old server, and install it on the new server.
10. Insert the new server into the rack, and connect the power cords to the
power supplies.
Note: Do not make any other cable connections at this time.
Configuring the replacement servers
Prerequisites
Obtain the necessary IP addresses to be used for the replacement server.
Servers shipped from the factory have not yet had the nas-preconfig script
run on them, so a replacement server will not have any IP addresses pre-
configured for your use. You need IP addresses for the following:
• Eth1 (cluster IP)
• Eth1 (testhost private IP)
• Eth0 (testhost external IP)
• 192.0.2.200/24 eth1 (cluster IP)
• 192.0.2.2/24 eth1 (testhost private IP)
• 192.168.4.120/24 eth0 (testhost external IP, which might vary)
120 Server replacement procedures
Hitachi NAS Platform 3080/3090 G2 Hardware Reference Guide