Hitachi 3080 G2, Справочник по аппаратуре

Страница: 106 / 129

Procedure
1. Navigate to Home > Server Settings > License Keys to load the
license keys.
2. Remove the previous license keys in the backup file, and add the new
keys.
3. Use
fc-link-speed
to verify and, if necessary, configure the FC port
speed as required.; for example:
a. Enter
fc-link-speed
to display the current settings.
host:$ fc-link-speed
FC 1: 4 Gbps
FC 2: 4 Gbps
FC 3: 4 Gbps
FC 4: 4 Gbps
b. Enter
fc-link-speed -i port_number -s speed
for each port.
host:$ fc-link-speed -i 1 -s 4
Set interface 1 link speed OK
FC 1: 4 Gbps
host:$ fc-link-speed -i 2 -s 4
Set interface 2 link speed OK
FC 2: 4 Gbps
host:$ fc-link-speed -i 3 -s 4
Set interface 3 link speed OK
FC 3: 4 Gbps
host:$ fc-link-speed -i 4 -s 4
Set interface 4 link speed OK
FC 4: 4 Gbps
c. Enter
fc-link-speed
to verify the settings.
host:$ fc-link-speed
FC 1: 4 Gbps
FC 2: 4 Gbps
FC 3: 4 Gbps
FC 4: 4 Gbps
4. Use the
fc-link-type
command to configure the server in fabric (N) or
loop (NL) mode.
5. Modify zoning and switches with the new WWPN, if you are using WWN-
based zoning.
If you are using port-based zoning, the no modifications are necessary
for the switches configurations.
6. Open Storage Navigator and reconfigure LUN mapping and host group on
the storage system that is dedicated to the server with the new WWPNs.
Perform this step for every affected server port.
7. If the server does not recognize the system drives, enter
fc-link-reset
to reset the fiber paths.
8. Enter
sdpath
to display the path to the devices (system drives) and
which hport and storage port are used.
9. Enter
sd-list
to verify the system drives statuses as OK and access is
allowed.
10. Enter
span-list
to verify the storage pools (spans) are accessible.
106 Server replacement procedures
Hitachi NAS Platform 3080/3090 G2 Hardware Reference Guide