Hioki 9605-01, Инструкция по эксплуатации, Страница: 68 / 100

62
────────────────────────────────────────────────────
8.3 Command Reference
────────────────────────────────────────────────────
Syntax
:MEASure:ITEM:HARMonic:NORMal
<NR1>,..(up to 5 items)
<NR1> = 0 to 63
Example ":MEASure:ITEM:HARMonic:NORMal
9,1,9,9,0"
As the default output items for the
normal measurement, H U1, HI1, HP1,
HTRU1, HTRI1, HTFU1, HTFI1 are
specified.
Function Sets the default items (rms value, active
power, total harmonic distortion ratio) to
be transferred in the response message
to the ":MEASure:HARMonic?" query
in the default mode.
The item is set as shown below by
setting bits, to specify a single
numerical value.
Note
If the setting value is out of range, an
execution error occurs.
128 64 32 16 8 4 2 1
bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0
RMS value data1 - - HI3 HI2 HI1 HU3 HU2 HU1
Power data2 - - - -
HPSUM
HP3 HP2 HP1
THD-R data3 - - HTRI3 HTRI2 HTRI1 HTRU3 HTRU2 HTRU1
THD-F data4 - - HTFI3 HTFI2 HTFI1 HTFU3 HTFU2 HTFU1
Frequency data5 - - - - - - - HF
Syntax
MEASure:ITEM:HARMonic:NORMal?
Response
syntax
":MEASURE:ITEM:HARMONIC:NORMAL
<0-63>,..(up to 5 items)
"
Example
Transmission
Response
":MEASure:ITEM:HARMonic:NORMal?"
":MEASURE:ITEM:HARMONIC:NORMAL
9,1,9,9,0"
Function Queries the setting items specified by
the ":MEASure:ITEM:HARMonic:
NORMal" command.
:MEASure:ITEM:HARMonic:NORMal
Sets the output item for the harmonic measurement value.
:MEASure:ITEM:HARMonic:NORMal?
Queries the output item for the harmonic measurement value.