Hino 600, Руководство по ремонту, Страница: 96 / 451

CLUTCH MAIN UNIT (EATON 1402) CL02–25
13. INSTALL THE TRANSMISSION MOUNTING BOLTS AND TORQUE
TO THE PROPER SPECIFICATION.
Tightening Torque:
37.5-48.5 N

m{382-494 kgf

cm, 28-35 lbf

ft}
IMPORTANT POINT-SET-UP
1. ADJUST LINKAGE
(1) Adjust the clutch linkage until the yoke fingers contact the release
bearing (zero free-play in the cab).
(2) Loosen the lock nut and turn the push rod counterclockwise until the
release bearing contacts the release lever plate or release lever.
(3) Fully press the pedal up to 5 times to move the release bearing
slightly closer to the transmission and gain free-play in the cab.
2. ADJUST THE FREE TRAVEL
(1) Turn the push rod counterclockwise until the release bearing contacts
the release lever plate or release lever.
(2) Turn the push rod clockwise about 3 1/3 turns.
(3) Tighten the lock nut.
SHTS02Z020200055
Stroke
pedal
5 times
SHTS02Z020200056
Master cylinder
Push rod
0
SHTS02Z020200057
Lock nut
3.18
SHTS02Z020200058
Standard: Clearance between release bearing and
release yoke: 3.18 mm {0.125 in.}