Hino 600, Руководство по ремонту, Страница: 159 / 451

PROPELLER SHAFT (SPL 100, 140) PP02–19
(3) Before installing the new center bearing assembly, be sure to fill the
entire cavity around the bearing with waterproof lubricant. (See photo
131, above.) Enough lubricant must be applied to fill the cavity to the
extreme edge of the slinger surrounding the bearing. Lubricants must
be water proof. See Table, below for recommended lubricants.
! WARNING
Inadequate lubrication can cause driveline failure, which can result in
separation of the driveline from the vehicle. A separated driveline can
result in death, serious personal injury or property damage.
(4) Carefully align the new center bearing assembly with the ground sur-
face of the midship tube shaft. Physically push the center bearing
onto the midship tube shaft.
(5) Press remaining slinger on end yoke using a section of tubing to avoid
damaging slinger.
(6) Using a soft-faced hammer, tap the yoke onto midship tube shaft,
making sure phasing marks from driveshaft removal procedure are in
line. Continue to tap the yoke until it is completely seated against the
center bearing.
(7) Install a washer (if required) and new midship nut and torque nut to
specifications. See midship nut specifications, Table.
! WARNING
Failure to torque midship nut to required specifications can cause
driveline failure, which can result in separation of the driveline from
the vehicle. A separated driveline can result in death, serious per-
sonal injury or property damage.
SHTS04Z040200051
RECOMMENDED CENTER BEARING LUBRICANTS
LUBRICANTS SOURCE
Rykon Premium No. 3 Amoco Oil Company
Amolith 8516 Amoco Oil Company
Van Talgar No. 4 Exxon Company
SHTS04Z040200052
SHTS04Z040200053
MIDSHIP NUT SPECIFICATIONS
SERIES NUT P/N
WASHER
P/N
HEAD
SIZE*
NUT TORQUE
N

m LB. FT.
SPL100 TBD TBD TBD TBD TBD
SPL140 250-74-11 230123-6 41mm* 644-712 475-525
* A 1 5/8" socket may be used.