Hino 600, Руководство по ремонту, Страница: 103 / 451

CLUTCH CONTROL CL03–3
INSPECTION AND ADJUSTMENT
EN02Z0203H300001
AIR BLEEDING
1. BLEED THE AIR FROM HYDRAULIC LINE.
NOTICE
•
Do not mix the clutch fluid with different types or brands.
• Be careful not to spill clutch fluid from the reservoir tank or from
the air bleeder during air bleeding. Clutch fluid can damage the
paint finish on the body or floor.
• There are two methods of bleeding, gravity bleeding and manual
air bleeding.
2. GRAVITY BLEEDING
(1) Connect a funnel to a vinyl tube.
(2) Connect the other end of the vinyl tube to the bleeder screw.
(3) Hold the funnel about 1.5 m {4.92 ft} higher than the reservoir tank.
(4) Loosen the bleeder screw and pour the clutch fluid into the funnel.
(5) Observe the flow of clutch fluid into the reservoir tank.
(6) When the air bubbles cease, close the bleeder screw.
(7) Check the fluid level. If necessary, add or remove clutch fluid in order
to match the "MAX" level.
3. MANUAL BLEEDING
(1) Fill the reservoir with clutch fluid.
(2) Connect the bleeder tube to the slave cylinder bleeder screw. Place
the other end of tube in a container half-filled with clutch fluid.
SHTS02Z020300002
1. Funnel filled with clutch fluid
2. Vinyl tube (inside diameter: 6 mm)
3. Bleeder
4. Slave cylinder
5. About 1.5 m {4.92 ft}
6. Clutch pedal
7. Master cylinder
8. Reservoir tank
SHTS02Z020300003