Hino 600, Руководство по ремонту, Страница: 423 / 451

ABS (ABS : FULL AIR) BR03–20
ADDITIONAL PRECAUTIONS
1. Make sure the model's starter switch is in the OFF position
before unplugging the harness connector from the ABS ECU.
2. Make sure to unplug all the harness connectors from the ABS
ECU before performing welding on the chassis or body of the
vehicle. Also be careful that welding sputter does not get onto
the harnesses.
3. When cleaning the interior of the model, make sure water does
not get onto the ABS ECU, various relays, connectors, or any
other component.
4. Use of a circuit tester
• If a circuit tester is being used, always use one with an internal resis-
tance greater than 100 k

inside the voltage measurement range.
5. Installation of a radio or other electronic equipment
• All electronic and radio equipment installed on the vehicle must be
mounted as far away from the ABS ECU and wire harness as possi-
ble. Installation of certain electronic and radio equipment can also
cause the ABS ECU to malfunction. All such equipment must also
conform to all applicable laws. If you wish to install a radio or other
electronic equipment, please contact your Hino service representa-
tive.
6. Quick battery charge
• When charging batteries using a quick charger, do it with both battery
terminals removed.
7. Installation of electrical equipment inside of the cab
• When installing an air conditioner or other electrical equipment inside
of the cab, be careful not to damage the engine, chassis, and wire
harnesses inside the cab. Moreover, do not forget to plug the harness
connectors unplugged during the installation.