Hillrom Compella, Инструкция по эксплуатации

Страница: 38 / 116

Standard Features
24 Compella™ Bariatric Bed System Instructions for Use (178951 REV 6)
Siderails in the raised position are intended to make the patient aware of the proximity of the edge of
the support surface and to assist in patient entry and exit.
Line-of-Site® Angle Indicators
1. The Line-of-Site® Head Angle Indicators on the head siderails mechanically
show the approximate angle of the head section from -8° to +56° with respect
to the floor. The degree where the indicator ball rests is the approximate angle.
2. The digital head angle display on the caregiver control pods that are
on the intermediate siderails gives a more accurate degree of head
elevation.
3. The Line-of-Site® Tilt/Reverse Tilt Angle Indicators on the intermediate
siderails give an estimated degree of bed tilt.
To Lower a Siderail
Lift up on the recessed blue release handle that is on the
lower part of the main siderail support. The siderail has a
dampening mechanism that slowly lowers the siderail.
NOTE:
Gently leaning into the siderail may make it easier to latch
and unlatch in some situations. For example, this may be
helpful immediately after you have fully retracted the bed
width.
To Raise a Siderail
1. Pull the siderail up, and push it in until it latches into
the locked position. You will hear a
click when the
siderail latches into the locked position.
2. After you hear the click , gently pull on the siderail to make sure it is latched correctly.
NOTE:
Because siderails are reinforced for the patient environment, the intermediate siderail may seem heavy.
CAUTION:
Caution —Do not use the siderails to move the bed. Always push or pull from the headboard or
footboard. Otherwise, equipment damage could occur.