Hill-Rom 2000009, Руководство по обслуживанию

Страница: 66 / 118

66 www.liko.com
Plastic housing, grey
Bandmagasin, grå
Assembly Instruction
Monteringsanvisning
Prod. No. 20090060
5.275
Roll the strap up until the red
mark reaches the plastic housing.
Push the emergency lowering
handle down and pull the strap
away.
Pull the rest of the strap out and
remove the plastic housing. Mount the strap through the new
plastic housing with the red mark
towards the plastic housing and
then as shown above.
Remove the pin. Do not let go of
the spring loaded wheel, since the
tension will release.
Mount the strap through the slot in
the axle and the same way back.
Note! The axle has two different
sides. Place the pin as shown to
lock the strap.
Push the plastic housing on to the
strap joint.
NOTE
- After changing plastic housing the SSP Limit Switch must be tested by lifting maximum load all the way up to the highest
position through the entire lifting range.
- With the emergency stop out, move the lifts trap all the way up against the SSP Limit switch. Check that the motor does not
operate when touching the SSP Limit switch.
- Make sure the spare part is mounted according to the assembly instruction.
- Check all functions related to the changed spare part.
- Repairs and maintenance may only be performed by personnel authorized by Hill-Rom/Liko and using original Liko spare parts.