Preventative Maintenance
105
www.liko.com
7.0
Instructions regarding the check points for
Golvo 7000/7007
7. Inspect gear rack for worn teeth and cracks where
stop nut contacts back surface (see arrow).
Inspect friction plates. Replace if worn or damaged.
Prod. No.
20090038 Gear rack set
20090072 Friction Plates 2,8-3,4 mm
8. Clean the friction plates/sliding surface and then
lubricate with PTFE grease. Reassemble middle
beam.
9. With middle beam at full extension, insert base motor.
Verify the stop screw is tight and the nut is in the
FRUUHFWRULHQWDWLRQ7KHÀDWRIWKHKH[PXVWEH
positioned parallel with the end of the gear rack.
10. Reassemble the mast and the middle beam to legs.
Slide middle beam inserts in until the gear rack
touches the drive shaft gear.
Note
: Do not engage gear rack!
11. To set base width start base motor while applying
inword force on both legs. After the upper and lower
gear rack engage with the base motor drive gear,
both legs will retract.
Verify that distance A & B are equal.
D
A
B
6. Pull out the middle beam inserts.
5b Base opening & closing linkage
Содержание 2000009
Страница 2: ...LNR 1HGUH YlJHQ 6 XOHn 6ZHGHQ WHO ID LQIR OLNR VH ZZZ OLNR FRP...
Страница 98: ......
Страница 117: ......
Страница 118: ...Manufacturer Liko AB 6 XOHn Sweden LQIR OLNR VH www liko com...