© Hikvision
Figure 5-15
Tampering Alarm
2.
Check Enable checkbox to enable the tampering detection.
3.
Set the tampering area.
4.
Set sensitivity level. Higher level means easier to trigger.
5.
Click
tab to enter the arming schedule setting interface. The arming
schedule configuration is the same as the setting of the arming schedule for motion detection.
Refer to Section 5.2.1 Configuring Motion Detection.
6.
Click
tab to select the linkage method taken for tampering, notify
surveillance center, send email and trigger alarm output are selectable. Refer to Section 5.2.1
Configuring Motion Detection.
7.
Click
to save the settings.
5.2.3
Configuring Alarm Input
Steps:
1.
Enter the Alarm Input settings interface:
Configuration > Event > Basic Event > Alarm Input
2.
Choose the Alarm Input No. and the Alarm Type. The alarm type can be NO (Normally Open)
and NC (Normally Closed).
Содержание DS-2DE4425W-DE3
Страница 1: ...Network Speed Dome User Manual UD09562B...
Страница 9: ...Hikvision SADP SOFTWARE INTRODUCTION 113...
Страница 124: ...Hikvision Figure A 1 2 Modify Network Parameters...
Страница 125: ......
