Highway Equipment Company NEW LEADER NL450C, Руководство пользователя

Страница: 39 / 102

NEW LEADER
HEADER
39
NL450C
Please Give Part No., Description
& Unit Serial No.
307306-B
Page Rev. A
L5034G4 LUBRICATION AND MAINTENANCE
CHART
The spreader should be regularly lubricated with the lubricants recommended in this manual in accordance with
the following chart:
SPREADER
LOCATION PLACES METHOD FREQUENCY
1. PTO Driveline (Figure 23)
a. Inner/Outer Tube Profile 1
Grease Gun
6-10 pumps
Every 8 Hours of
Operation
b. Nylon Bearing Ring 2
Grease Gun
2-3 pumps
c. *Grease PTO Spline 1 Hand Grease
See above or each time
tractor & PTO driveline
attached.
d. Tractor Yoke (Cross & Bearing) 1
Grease Gun
5-6 pumps or until purge
Every 8 Hours of
Operation
e. **CV Yoke (Cross & Bearing) 2
Grease Gun
30 pumps
f. Pump Yoke (Cross & Bearing) 1
Grease Gun
5-6 pumps or until purge
g. Shield 2
Grease Gun
2-3 pumps on each
* - Not Shown ** - Also feeds ball cavity.
Hydraulic System (Figure 24)
2. Reservoir 1 Oil
Check Daily. Change
Annually
3. Filter 1 Check daily; Change when indicated (Red)
Conveyor
4. Dragshaft Bearings (Figure 25) 2 Grease Gun Weekly
5. Idler Shaft Bearings (Figure 26) 2 Grease Gun Weekly
6. Take-Up Screws (Figure 26) 2 Hand Grease Weekly
7. Chain Oiler (Figure 27) 1 Oil Mixture Daily, After Use
8. Gear Case (Figure 28) 1 Gear Oil
Check Monthly; Change
Annually
Jack Assembly (Figure 29)
9. Gears 1 Grease Gun Annually
10. Tubes 1 Grease Gun Weekly
Spinner (Figure 29)
11. Shaft 2 Grease Gun Weekly
12. Jack 2 Grease Gun Weekly
NOTE: Unusual conditions, such as excessive dust, temperature extremes or excessive moisture may require more
frequent lubrication of specific parts.
OPER. & MAINT
.
LUBRICA
TION & MAINTENANCE