NEW LEADER
HEADER
37
NL450C
Please Give Part No., Description
& Unit Serial No.
307306-B
Page Rev. A
LUBRICATION AND MAINTENANCE CONTINUED
7.
Install hardened spacer and nuts, finger-tight, at 12 o’clock and 6 o’clock
positions. Rotate wheel 180° and make sure wheel is fully seated against
drum. Repeat as needed. Install spacers and nuts
8.
finger-tight on remaining studs.
9.
Tighten nuts to 50 ft-lb (67.8 N-m) following a crisscross sequence as
shown in Figure 22.
10.
After the wheel is installed inspect the seating of the wheels on all four
pilots and turn the wheel checking for irregularity of the wheel assembly.
This will ensure the wheel is seated on the pilots and flat against the
drum.
Figure 21 - Nut Tightening
11.
Tighten all nuts to 450-500 ft-lb (610.2-678 N-m) using the crisscross sequence as shown in Figure 32.
12.
Repeat torque sequence until all nuts are consistent to 450-500 ft-lb (610.2-678 N-m).
PTO DRIVELINE LUBE AND ALL GREASE POINTS
See
Lubrication and Maintenance Chart
section.
STORAGE
General
1.
Inspect and lube per maintenance instructions.
2.
Empty any material from unit.
WARNING
Never store implement with material in bin. Implement could tip and crush or strike
someone causing serious injury or even death.
3.
Pressure wash
4.
Store indoors on a hard, level surface, with blocked tires to prevent movement.
PTO DRIVELINE
Place PTO driveline in storage position, as shown in Figure 22, and
secure with pin when implement is not in use.
OPER. & MAINT
.
LUBRICA
TION & MAINTENANCE
Содержание NEW LEADER NL450C
Страница 4: ...INSERT CURRENT NEW LEADER WARRANTY...
Страница 52: ...52 Please Give Part No Description Unit Serial No 307306 B Page Rev A NL450C NEW LEADER NOTES N O T E S...
Страница 90: ...90 NEW LEADER Please Give Part No Description Unit Serial No NL450C 307306 C Page Rev A NOTES PA R T S L I S T...
Страница 100: ...100 NEW LEADER Please Give Part No Description Unit Serial No NL450C HEADER BRAKE LINES PA R T S L I S T...
