Highway Equipment Company New Leader MARK V DGPS-Ready, Общее руководство

Страница: 34 / 45

P l e a s e G i v e P a r t N o . , D e s c r i p t i o n a n d U n i t S e r i a l N o .
HIGHWAY EQUIPMENT COMPANY
32
89008-A
Page Rev. A
OPERATING PROCEDURES CONTINUED
Spinner speed alarms
The Mark V compares the actual spinner speed to the target spinner speed setting stored in the active
job. The following alarms may occur.
“SPINNER SPEED TOO HIGH” – actual spinner speed is 50 rpm or more above the target speed.
“SPINNER SPEED TOO LOW” – actual spinner speed is 50 rpm or more below the target speed.
Note: If you do not have a spinner speed sensor or the sensor is faulty, the “Spinner speed too low”
alarm will be continuous. Setting the “Spinner pulses/rev” to zero (found under SETUP key and
MACHINE SETTINGS key) will disable the alarm.
CLEARING TOTAL AND AREA APPLIED
At the main screen, press the CLEAR button. A warning message appears. Press the ACCEPT key to
clear the total applied and area applied.
The total applied and area applied must be cleared when switching between tons/ac jobs and pounds/ac
jobs. Otherwise the total applied number will be incorrect.
DGPS-5000 AND LIGHTBAR
The setup and operation instructions for the DGPS-5000 and Lightbar come with that system in the
form of a manual insert. Refer to those instructions.