Highway Equipment Company New Leader MARK V DGPS-Ready, Общее руководство

Страница: 26 / 45

P l e a s e G i v e P a r t N o . , D e s c r i p t i o n a n d U n i t S e r i a l N o .
HIGHWAY EQUIPMENT COMPANY
24
89008-A
Page Rev. A
PROGRAMMING A JOB CONTINUED
General instructions to change the settings shown on this screen:
a) Use the Up or Down Arrow key to highlight a setting.
b) Press the EDIT key. The value will be highlighted.
c) Press the Up or Down Arrow key to change the value. [Note Application rate, Spread width,
Product density, Spinner speed, and Calibrated CFR values can be set one digit at a time. Press
the Left or Right Arrow Key to move a single cursor to the digit to change. Press the Up or
Down Arrow key to set the digit to the desired value. Move the cursor to the right or left and set
all digits to the correct value.]
d) Press the ACCEPT key to accept the new value for the setting. If you decide to keep the old
value press the CANCEL key.
Changing the Product value is detailed separately under the “Product” heading on the following pages.
Job Setting Details
Units/acre
Set to TONS when applying lime or other high rate product by the ton (metric units are tonnes).
Set to POUNDS when applying fertilizer or like product by pound (metric units are kilograms).
Application Rate
Set to the desired nominal application rate for the job. This setting automatically becomes the
application rate when the job is activated and will appear on the main screen if Rate is selected as a
display line.
Spread Width
Set to the effective spread width in feet (metric units are meters). New Leader recommends pan testing
every new product to determine the actual effective spread width for given spinner speeds and fan
settings. Consult your spreader manual for instructions on pan testing.
When an optional New Leader DGPS-5000 and Lightbar are connected, the swath for the Lightbar is
automatically set equal to the spread width.
Feedgate opening
Set to the correct feedgate opening in inches for the job (metric units are centimeters).
The actual feedgate opening of the spreader must match the setting for the
active job or the rate applied will not be correct!
IMPORTANT!