Highway Equipment Company New Leader MARK V DGPS-Ready, Общее руководство

Страница: 21 / 45

P l e a s e G i v e P a r t N o . , D e s c r i p t i o n a n d U n i t S e r i a l N o .
HIGHWAY EQUIPMENT COMPANY
19
89008-A
Page Rev. A
CALIBRATION AND MACHINE SETTINGS CONTINUED
Distance Calibration: Radar
NOTE: A job must be active to calibrate radar.
From the main screen, press the SETUP key. Press the CAL RADAR key. The screen in Figure 7
appears.
a) Find a good place to travel back and forth in a straight line. Measure and mark off a travel distance.
A minimum distance of 200 feet is required.
b) Press the Display Selection key next to the display line for “Actual Distance”. A box should appear
around the display line. By pressing the Up or Down Arrow keys, set the “Actual Distance” to equal
the distance you marked off.
c) Position the vehicle at the beginning of the marked off distance.
d) Press START TRAVEL key and drive vehicle to the end of the marked off distance. Stop at the end
marker.
e) Press STOP TRAVEL key.
f) Press PERFORM CAL key.
g) Repeat steps c-e to verify the displayed “Measured Distance” equals the “Actual Distance”. If not,
repeat the calibration.
h) Press EXIT key.
i) Press the Menu Key to return to the main screen.
j) Traveling in a straight line, verify the displayed “Ground Speed” on main screen is correct.
DISTANCE CALIBRATION: RADAR
ACTUAL DISTANCE:
200
ft
MEASURED DISTANCE:
0
ft
PULSES / 100 FT:
2000
ft
START
TRAVEL
CLEAR
DISTANCE
PERFORM
CAL
EXIT
Figure 7