15
CAUTION: H
!
G
.
C
.
K
,
,
,
.
E
.
C
.
A
.
P -O
A
T
S
P
:
For the Cataly c Monitor.
C
B
H
:
Pull out to open the bypass for
loading; push in to engage the cataly c combustors.
L
D
:
Allows access to the
fi
rebox for loading.
C
G
:
Ceramic material withstands high tempera-
tures and allows a view of the
fi
re.
D
H
:
Rotate to latch/unlatch the loading door.
E
L
:
Designed to catch ash and embers.
S
-
A C
:
Provides extra air to the
fi
re during
start-up and refueling. Pull to open and push to close
C
A C
:
Regulates the amount of air fed
to the
fi
re. Pull-out to open and push-in to close.
C
B
C
:
Turn the Convec on Blow-
er on and o
ff
and adjust the fan speed.
NOTICE:
Before ligh ng the wood heater for the
fi
rst me
ensure that any inspec on required has been completed
and passed by the local Building Inspector, Fire O
ffi
cial, or
other Authority Having Jurisdic on (AHJ).
Smoke and CO detectors should be installed on every
fl
oor
of your home. A smoke detector that is installed in the same
room as the wood heater should be located as far away from
the wood heater as possible. See
Page 2
. Many states have
requirements manda ng the installa on of smoke and CO
detectors. Those regula ons must take precedence.
Be sure you have no
fi
ed your homeowner's insurance com-
pany that a wood heater has been installed in your home.
Inquire whether they require their own inspec on.
It is recommended that a "Type A B C"
fi
re ex nguisher be
kept in close proximity to the wood heater in the event that
hot embers should escape the
fi
rebox during the loading of
fuel and/or the removal of ashes. Please use all due care
when loading or servicing the wood heater.
• Never throw water on a burning wood heater.
• Thermal shock could break the ceramic glass, exacerbat-
ing the problem.
• Hot steam could increase the risk of burns or scalding.
ALWAYS USE SAFE BURNING PRACTICES:
B
S
W
F
O
.
This wood heater is designed and approved for the burn-
ing of cord wood fuel only. Never burn any type of coal in
this heater. Burning any type of fuel other than cord wood
in this wood heater is against all safety tes ng and will
void all warran es.
D N
U C
F
S
F
.
Never use gasoline, gasoline-type lantern fuel, kerosene,
charcoal lighter
fl
uid, or similar liquids to start or “freshen
up” a
fi
re in this wood heater. Keep all such liquids well
away from the heater at all mes. Storing these or other
fl
ammable liquids near a wood heater could cause a
fi
re.
B
D
F
.
Do not use grates, andirons, or other methods to support
or elevate fuel.
D N
O
E
M
O
-
F
W
H
.
If any part of the wood heater, the chimney, or the chim-
ney connector glows, you are over-
fi
ring. If over-
fi
ring oc-
curs, close all combus on air controls immediately. Over-
fi
ring can cause damage to the wood heater and may
cause a
fi
re.
ATTENTION:
Any tags or s ckers must be removed and
op onal plated loading doors and/or trim must be cleaned
with ammonia free glass cleaner and a so rag BEFORE light-
ing the wood heater for the
fi
rst me. Failure to clean the
glass or plated
fi
nish properly to remove any
fi
ngerprints or
oils may permanently mar the
fi
nish. Never a empt to clean
the door
fi
nish or door glass when hot.
ATTENTION:
Your new wood heater has been painted
with high temperature (1200°) stove paint. During the
fi
rst
few
fi
rings the heater may give o
ff
slight smoke, odors and/
or vapors while the paint and oils used in manufacturing
cure. These odors may be irrita ng to suscep ble individu-
als. Open the windows in the room where the heater is in-
stalled while the paint cures.
M
2500 F
C