High Valley 2500, Руководство пользователя, Страница: 14 / 28

14
F I S K
A
B
C
D
FIREPLACE I NSERT S URROUND I NSTALLATION
A er the fi replace insert has been installed into the fi replace, and the liner or direct-connect has been a ffi xed to the insert
fl ue, the Insert Surround can be installed. Ensure that the ven ng is installed properly and the damper sealed to prevent
smoke from entering the home. Verify that all clearances to combus ble materials meet or exceed those outlined in the il-
lustra on on
Page 13 . It may be advisable to wait to install the Insert Surround un l a er the installa on has been inspected.
The building inspector, or other Authority Having Jurisdic on (AHJ), may wish to view the ven ng and fi replace block-o ff .
Inspect the contents of the Insert Surround shipping carton for dam-
age and/or missing parts. Contact your High Valley dealer if neces-
sary to report discrepancies. The package should contain:
A. Insert Surround in the size, style, and color of your choice.
B. A roll of self-adhesive Fiberglass Insula on.
C. A roll of self-adhesive Fiberglass gasket material.
D. Hardware Kit containing 4 cap-screws and a 1/8" Allen wrench.
• Cut three (3) pieces of fi berglass insula on (B) to length to fi t the
top and sides of the Surround.
○ Remove the paper backing and adhere the insula on to the
back of the Surround. (The insula on need not be at the very
edges of the surround, but must frame the
fi replace opening.)
• Cut three (3) pieces of gasket material (C) to length to fi t the fl ang-
es on the inside top and side edges of the Surround.
○
Remove the paper tape and adhere the gaske ng to the inside
surface of the
fl anges (facing the Insert body).
• Start the four pressure screws into the tabs in the Surround.
○
Do not let the cap-screw threads project through the tabs to
prevent marring the Model 2500 Insert
fi nish.
Check that the Insert is centered, side to side, in the fi replace open-
ing. The front edge of the Insert top should be no more than 10 ⅝ ",
and no less than 7 ⅝ ", from the face of the fireplace.
• Remove the Bay Windows from the Model 2500. (See below)
• Carefully slide the Insert Surround onto the Fireplace Insert.
○ Do not twist or force the Insert Surround onto the Insert. Take
care not to mar the Fireplace Insert or Surround
fi nish.
• Hold the Insert Surround fi rmly against the fi replace face and
ghten the four pressure screws evenly. Do not over- ghten.
• Replace the Bay Windows on the Model 2500.
F I S P S
M 2500 B W :
The Model 2500 has Bay Windows that project beyond the sides of the body. They must be
removed to allow the Surround to slide onto the insert. Each Bay Window is fastened in place with two (2) 1/4"-20 x 3/4"
long bolts. To access the bolts it is necessary to reach into the
fi rebox. Use a 7/16" socket, nut driver, or wrench to loosen
and remove the bolts. Remove the bo om bolts fi rst . While holding the Bay Window, remove the top bolt and the window.
An assistant is helpful. Reverse the procedure to replace the Bay Windows. Tighten the bolts snugly but do not over- ghten.
TIP: Applying some high temperature an -sieze to the bolts will make future removal easier.
M 2500 F I D
F V S V T V
F -B F I :
The Model 2500 has not been safety tested, and is not approved, for installa on into Factory-Built Fireplaces.