High Lifter PGL-KIT-RZRT, Руководство пользователя, Страница: 29 / 34

PGL-KIT-RZRT 29
b. Reattach the lower radius bar using the factory washer and lock nut. (18mm)[90 ft lbs]
22. BLEED BRAKES
NOTE:
When bleeding the brakes, start with the farthest caliper from the master cylinder.
CAUTION: ALWAYS wear eye protection like safety glasses. Brake fluid will damage finished surfaces. Do not
allow brake fluid to come in contact with finished surfaces.
a.
Bleeding the brakes is a two person job; you will need someone at the brake caliper and someone to pump
the brake foot pedal. Take precautions due to the vehicle being on jacks and/or jack stands.
b. Clean master cylinder cover thoroughly and remove the cover.
c. Add brake fluid to the indicated MAX level of the reservoir. (Any DOT 4 Brake Fluid)
d. Begin bleeding procedure with the caliper that is the farthest from the master cylinder. It should be this
sequence - (PA) REAR, (DR) REAR, (PA) FRONT, and then (DR) FRONT.
e. Install a box end wrench on the caliper bleeder screw. Attach a clean,
clear hose to fitting. Be sure the hose fits tightly on fitting. Now place the
other end of the hose into a clean container.
f. Have your brake buddy slowly pump the foot pedal until pressure builds
and holds. Have your buddy hold brake pedal down to maintain pedal
pressure. Now you open the caliper bleeder screw so the air and fluid
will displace into the container.
g. Close bleeder screw, and then have your buddy release the foot pedal.
NOTE: Do not release foot pedal before the bleeder screw is tight or air
may be drawn into the master cylinder... and you have to start all over
again!
h. Check the master cylinder fluid level.
NOTE: You must maintain at least 1/2” (1.27cm) of brake fluid in the reservoir to prevent air from entering
the master cylinder
i. Repeat these steps until clean fluid appears in the bleeder hose and all the air has been purged... Close
bleeder screw, pump brakes, hold pressure, open bleeder, close bleeder, release foot pedal, check master
cylinder.