High Lifter PGL-KIT-RZRT, Руководство пользователя, Страница: 25 / 34

PGL-KIT-RZRT 25
17. ADJUST REAR CAMBER
a. When checking the camber, it is necessary that the unit is leveled . You can do this by properly positioning
jack stands, bottle/floor jacks, and using a leveling tool. Please be careful and make sure the unit is secure
during this process.
b.
Now check the camber and determine if it is positive or negative. You want to set it to ZERO. To do this,
you can visually look down the side of your UTV and use an angle locator tool. If it is good, proceed to step
#19. If not, then continue following these steps.
c.
If the camber is (-) you will need to add a shim. If the camber is (+) you will need to remove a shim. You are
provided a 1/8” shim and a 1/16” shim for each portal to better achieve the correct angle. You can remove
or use both of them as needed.
d.
Loosen the nuts on the upper collar mount bracket, but do not remove them. You can simply slide the extra
shims in and out.
e.
Check the camber again. If it’s correct, proceed to step #21. If not, repeat the previous step until you
achieve the correct angle. NOTE: You can purchase more shims if needed
18. INSTALL REAR DRIVE SHAFT NUT WITH SHOULDER & PORTAL BOX LID CAP
a. With the portal box assembly in place, double check that the factory axle shaft is properly aligned into the
drive gear of the portal box.
b.
Apply LOCTITE 243 (Blue) to the supplied M18 machined nut with shoulder PGLC-AXNUT and tighten &
torque onto the drive shaft axle. (27mm)[180 ft lbs]