
Rev. 1.4 / 02-16-2017
DP450 Tap Water Iontophoresis System User Manual
15
In order to avoid skin irritation by excessive dose settings in
pulsed mode (where current flow is practically imperceptible), we
recommend that you assess your individual direct current thres-
holds for hands, feet, or armpits before you start the first treat-
ment session. To conduct axillary treatments, as a rule the dose should not
be raised above 15 volts, because the sensitive skin may otherwise get
burnt.
Begin Treatment (Programming Mode)
After completion of the initial setup, the unit will automatically switch to Pro-
gramming Mode after about 6 seconds or when the ENTER button
is
pressed. The intended treatment time and dose will be displayed, based on
Profile or manual mode. Before you start the actual treatment session, you
need to check and/or set the “time” and “dose” treatment parameters.
1) Setting treatment parameters:
If Profile has been selected, the device uses the saved treatment parame-
ters
1
. If the device is in manual mode, it will return to factory presets when
turned back on.
The numbers in the left window
TIME
DOSE
show the selected treatment
duration in minutes and the
numbers in the right window
show the selected treatment
dose in volts.
Select the desired treatment
dose
2
with buttons
and
, and the desired treat-
ment duration with buttons
and .
Each time you push one of these buttons, the corresponding treatment pa-
rameter is increased or decreased by one minute or one volt, respectively.
Hint:
By holding one of the push buttons down, you can continuously in-
crease or decrease the corresponding treatment parameter.
1
pulse-width, time and dose
2
Select the dose in accordance with your doctor’s orders or use the table of factory pre-set treatment
parameters for guidance.