Hi-Tech Solutions C5, Инструкция по установке и эксплуатации

Страница: 50 / 71

48 Changing Wireless Connection Settings
8. In the SeeData application, open Settings and check File Transfer . The system will
now save all the captured images. You can also optionally change the location of the
saved images.
9. Instruct the driver to drive the vehicle on the left side of the lane, on the right side, and
in the middle. Instruct the driver to repeat this at different speeds.
After each drive, check the images in the images folder. The goal is to capture as
many images as possible which show the license plate clearly. If the system is
configured to capture six images, all six should include the plate.
It is recommended to configure the system to capture images with different illumination
intensities. Check the images to see the plate in different light conditions.
If the camera is installed on a gantry and the system is set up for front LPR, then when
the vehicle is driven down the middle of the lane you should get x images with closer
and closer plates:
Figure 30: LPR When C5 Installed on a Gantry
If the camera is installed on a pole and the system is set up for front LPR, then when
the vehicle is driven down the middle of the lane you should get x images with closer
and closer plates moving diagonally:
Figure 31: LPR When C5 Installed on a Pole
10. Once the results are satisfactory, run a large-scale test. Use as many different
vehicles as you can. Drive them 20-30 times at different speeds and in different lane
positions. Check the results, and fix any problems found.