Hi-Tech Solutions C5, Инструкция по установке и эксплуатации

Страница: 33 / 71

C5 Installation and Operation Guide Equipment Specifications Data sheets 31
2. Specify the VMD settings as described in the following table:
Parameter Description
Enabled Select this option if the system uses the internal motion detector to
detect motion.
Do not select this option if the system uses a loop detector to detect
motion.
Sensitivity The sensitivity level of the VMD algorithm.
Top The distance in pixels from the top of the image, defining the top of the
hot rectangle.
Left The distance in pixels from the left edge of the image, defining the left
edge of the hot rectangle.
Right The distance in pixels from the right edge of the image, defining the
right edge of the hot rectangle.
Bottom The distance in pixels from the bottom of the image, defining the
bottom of the hot rectangle.
Important: VMD settings take effect only after restarting C5.
Refer to
Restarting C5 .
Restarting C5
f
To restart C5:
1. In the C5 Portal home page, click Turn Off . The Turn Off page appears (Figure 13).
2. Click Restart . C5 shuts down and restarts. After about 2 minutes it is up again.
Note that any change in parameters requires application restart.
Click "Restart" button on each relevant page.
Shutting Down C5
f
To shut down C5:
1. In the C5 Portal home page, click Turn Off . The Turn Off page appears (Figure 13).
2. Click Turn Off . C5 shuts down.
To start C5, disconnect and reconnect it to the mains.