04.24.2015
Mutant Hot Glue DIY assembly manual v1.05
PG9
HEXINVERTER ÉLECTRONIQUE, 2015
STEP_04: THAT2180, Test Jumper
•
After installing the jumper on the 2x3 pin header we cut up in the last step, you can solder it in for the
COMPRESSOR SPEED jumper.
•
Using a couple of left over component lead clippings, bend them into a ‘U’ shape which fit in the
gnd
and
SYMMETRY TEST POINT
locations, at the bottom right of the MAIN PCB.
•
Solder in the 10k trim potentiometer for the SYMMETRY ADJUST calibration point
•
Finally, solder in the THAT2180 VCA chip.
Be careful not to overheat it, and make sure the notch is aligned
where indicated!
NOTCH IS HERE
