04.24.2015
Mutant Hot Glue DIY assembly manual v1.05
PG8
HEXINVERTER ÉLECTRONIQUE, 2015
STEP_03: Pin Headers
•
Begin by using pliers to snap the 2x40 pin headers into (2x) 2x10 sections and (1x) 2x3 section, as shown. We
included an extra 2x40 header in case you have an accident, or some snapped during shipment.
•
Install the headers in the PCBs,
making sure to install the female headers on the CONTROL PCB
(not the MAIN
PCB). This is because the longer profile of the female headers will interfere with component pins on the MAIN
PCB.
•
Take your time checking alignment before and during soldering. You want to make sure that the
Take your time checking alignment before and during soldering of the pin headers.
You want
to make sure that the PCBs line up nicely so that the stscrews that hold the PCB
sandwich together are aligned properly.
It might be a good idea to screw the PCBs together
while you solder the pin headers, if you want to guarantee they are aligned well!
CONTROL PCB
MAIN PCB
The 2x3 header is saved for the
compressor speed jumper on the
MAIN PCB
