04.24.2015
Mutant Hot Glue DIY assembly manual v1.05
PG13
HEXINVERTER ÉLECTRONIQUE, 2015
STEP_09: Jacks + Toggle Switch
•
Gently flip the control board with panel attached over so that the jacks fall down with gravity against the panel.
Sit the assembly gently on your desk and
inspect to see that each jack is flush with the back of the panel
.
•
The jacks will be slightly lifted off of the PCB. Try to ensure that they are flush with the panel.
•
Unscrew the nut for the toggle switch slightly, to raise it to the same height as the panel.
•
When you are happy with the fit, solder each jack and toggle switch, going back to check that they are nicely
against the panel each time.
