Hettich CADRO, Техническая информация

Страница: 40 / 47

40 | 41
40 mm
18 mm
4 mm
8 mm
F1
1
9 mm
1
2 3
1 2
3 4
CADRO Glass display case.
1
The door stop set includes a plastic cap and a M4 x 16mm grub
screw to be fixed in the profile at the position F1 . F or this purpose,
a 3,3 mm core drilling has to be done into the profile into which an M4
thread is cut afterwards. The preparation of the profiles is ideally done
after planning and before the final assembly of the glass display case.
The threaded pin is then screwed in and covered with the matching
plastic sleeve.
2
+
3
The eccentric bore of the sleeve allows the door stop to be
adjusted by turning later on so that the glass door can accurately be
closed
4
. Thus, the door stop allows a compensation of up to 2 mm.
Choose a suitable knob as a handle for your display case door and fasten
it by screwing to the handle attachment before mounting the glass panel.
The attachment can now be placed anywhere on the edge of the glass
door and then be screwed tight. Thus, it is not necessary to drill a hole in
the glass door. Optionally, the ball spring plunger can then be mounted
in the frame.
PLEASE NOTE:
The use of the handle attachment in combination with the lighting
clip-on profile
, order no. 9 303 924, is not possible.
The door stop set can also be used as a glass shelf support inside the
diplay case and be mounted inside the profiles at any desired height.
Slight differences in height can precisely be adjusted using the eccentric
cover cap.
Assembly.
1
The glass shelf runs inside the profile frame at the front and back
and up to the glass panels at the right and the left. We recommend a
tolerance of approx. 1 mm.
Assembly with lighting profiles.
2
+
3
When using the lighting clip-on profiles in the display case
frame (see also page 42 | 43) t he shelf support penetrates the plastic
profile. For this purpose, the lighting clip-on profile is provided with a
9 mm drilling at the position of the core drilling for the grub screw.
The cover cap can now be slided until it reaches the aluminum profile
and has enough space for adjustment.
RECCOMENDATION:
To obtain congruent holes in the plastic and the aluminum profile,
always use the same stop plate. The plastic profiles can be clipped on a
short remaining piece of aluminum profile in the drilling area. Thus
they can be straigthly positioned in the drilling and tapping jig. After
drilling, the plastic profile can easily be detached.
Glass shelf
support
83143.****
Glass door handle
attachment
9 303 936 / 9 303 937
e.g. knob
Cadria
Glass door stop.
Glass shelf support. Glass door handle attachment.
Clip-on profile
83070.****
Lighting
clip-on profile
83160.**** or
83161.****
Angle profile
for glass
panels
83067.****
Glass door stop
9 303 934 / 9 303 935