Hettich CADRO, Техническая информация

Страница: 33 / 47

32 | 33
F1
2
1
2
3
CADRO Glass display case.
Preparation of the profiles.
Inserting of the screws.
The screws are inserted the same way as done for the base frame
(see page 9) . However, M5 x 4 mm DIN 913 grub screws are used for
the glass profiles.
Silicon piping profile.
To prepare the profiles for firmly inserting the glass panels. the required
sides are equipped with pieces of the silicon piping profile 83085.****.
We recommend the use of one piece at each profile end and another one
every 25 cm (minimum).
Sealing strip.
Wherever glass panels are to be firmly mounted in the glass display case,
a 2 mm wide self-adhesive sealing strip is attached on the inner profile
edges (83170.***). Thus, the glass panels can be precisely and securely be
fixed.
Assembly.
1
The frame is assembled according to the order as described
on page 12 | 13.
2
Afterwards, all protective films must be removed from the
sealing strip.
3
Finally, the glass panels are inserted one after the other and
securely fixed using the clip-on profiles. (Page 34 | 35
4
to
9
)
RECOMMENDATION:
If the glass panels are slightly too large, the loosening of the screw
connection of the connectors may simplify the assembly. However,
in this case do not forget to screw them tight again before mounting
the clip-on profiles!
Grub screw
83140.****