Hettich CADRO, Техническая информация

Страница: 38 / 47

38 | 39
10 mm
21 mm
8,5 mm
4 mm
x
b
a
8
8
24 mm
10 mm
21 mm
8,5 mm
4 mm
x
a
b 8
8
24 mm
x
x
a
b
a
b
M3 x 15 mm
M3 x 15 mm
M3 x 10 mm
M3 x 10 mm
1
2
!
3
1
4
2
CADRO Glass display case.
The glass door lock can be used for glass doors with a thickness of 4 mm.
The profiles should be planned before the assembly of the frame and be
prepared with the corresponding drillings
(see figure below) .
The placement of the hole for the lock in the glass door must also be
planned and made as shown in the figure below.
PLEASE NOTE:
It is not possible to use the lighting clip-on profile
, order no. 9 303
924, on the side of the latch. Alternatively, a lock can be attached at
the top and bottom of the glas door if no lighting profiles are planned
in this area of the glass display case.
1
At first, the lock must be opened on the back. Then, the two screws
of the cover must be removed to take off the cover. The protective film of
the adhesive surface also has to be removed so that the lock can be stuck
to the glass door.
2
In order to fix the lock at the accurate position, the lock cylinder
must be at first passed through the hole in the glass door. Then …
1
… place the housing on the glass edge of the door and …
2
… press the adhesive surface firmly onto the glass surface.
The lock is now straightly and securely fixed.
3
Afterwards, the cover including the latch is reattached.
!
Please make sure that the locking cylinder and the latch is correctly
positioned!
If necessary, carry out a functional test before retightening the cover
screws.
4
Finally, the sleeves for the latch and the ball spring plunger are inser-
ted in the corresponding holes in the frame.
Glass door lock.
Drilling and hole dimensions.
Lock assembly.
Glass door lock (set)
9 303 932 / 9 303 933
CADRO Frame of glass display case CADRO Frame of glass display case
x
min
= 50 mm
x
min
= 50 mm
Drilling for lock = x + 14 mm
Drilling for lock = x - 6 mm
Drilling for ball spring plunger = x -4,5 mm
Drilling for ball spring plunger = x + 12,5 mm
Drilling dimensions for glass door DIN right Drilling dimensions for glass door DIN left
Glass door
Glass door Glass door