Hettich CADRO, Техническая информация

Страница: 32 / 47

32 | 33
F1
2
1
2
3
CADRO Glass display case.
Preparation of the profiles.
Inserting of the screws.
The screws are inserted the same way as done for the base frame
(see page 9) . However, M5 x 4 mm DIN 913 grub screws are used for
the glass profiles.
Sealing strip.
Wherever glass panels are to be firmly mounted in the glass display
case, a 2 mm wide self-adhesive sealing strip
, order no. 9 303 927, is
attached on the inner profile edges. Thus, the glass panels can be
precisely and securely be fixed.
Round cord seal
/
Silicon profile.
To prepare the profiles for firmly inserting the glass panels. the required
sides are equipped with pieces of the silicon piping profile
, order no.
9 303 926 . We recommend the use of one piece at each profile end and
another one every 25 cm (minimum).
Assembly.
1
The frame is assembled according to the order as described
on page 12 | 13.
2
Afterwards, all protective films must be removed from the
sealing strip.
3
Finally, the glass panels are inserted one after the other and
securely fixed using the clip-on profiles. (Page 34 | 35
4
to
9
)
RECOMMENDATION:
If the glass panels are slightly too large, the loosening of the screw
connection of the connectors may simplify the assembly. However,
in this case do not forget to screw them tight again before mounting
the clip-on profiles!
Grub screw
9 303 930