29
HMD8 DSP/
USER’S MANUAL
6.4.9
CROSSOVER
With the crossover section it is possible to set different bands for every output channel.
Remark:
the output channel you are acting on is indicated by the foreground color of the crossover panel.
The image below shows the crossover parameters that it is possible to set:
6 7
1
2
3
5
4
Type:
allows you to choose the type of crossover.
Name:
allows you to choose the name of the crossover.
Slope:
opens a drop-down menu that allows you to select the slope.
Frequency:
allows you to set the cut-off frequency by turning the knob or
entering the value from the keyboard.
Phase:
allows you to invert the signal phase by 180 °, whatever type or name
you select.
Copy panel:
opens the crossover copy panel.
Help:
to open the user guide.
1
2
3
4
5
6
7
WARNING:
the parameters are linked to each other in the order shown above. When a
parameter is changed, it may cause changes to other parameters. Be careful when
changing the parameters.
Remark:
the crossover of each output channel is linked to the currently selected source.
For each source it is necessary to set the crossovers on the output channels.
• TYPE
The first parameter to set is the type and the available types are:
1. FLAT:
With
Flat type
the crossover display hides the other settings.
2. HIGH PASS
With
High Pass type
the crossover panel allows the name, slope and frequency selection.
3. LOW PASS
With
Low Pass type
the crossover panel allows the name, slope and frequency selection.
6
