Installation Manual
Version 1.1
4
Part Number MAN-000014
Preparation
Before beginning the installation process, you need to make sure that the area surrounding each leg is clear of dirt,
ice, or any other debris that may cause the ‘A’ frame to not sit flat. If this is not done it could cause the bin to lift
unevenly and give a false reading.
List of Common Parts to be Installed
•
MCA-000221/222
– BinTrac Dual Breeder Control
•
MLB-XXXXXX
– 2.5/5.0K/10k Ag Load Cell Bracket Assembly
•
MSA-006000
– Smart Summing Box 6-Leg
OR
MSA-004000
– Smart Summing Box 4-Leg
•
ASY-000237
– BinTrac Power Supply PS17
Tools Needed
•
1
– 1 1/8” open-end wrench
•
2
– 3/4” wrenches
•
1/2” Drill
•
1/2” Hammer drill or Hilti cement drill
•
1/2” metal bit
•
1/2” cement bit
•
5/16” self-tapping screws
•
5/16” hex screw tip
•
1/2” cordless drill
•
Impact wrench with 1 1/8” and 3/4” sockets (optional)
•
Small flat-head screwdriver
•
#2 Phillips screwdriver
•
Center punch
Supplies Needed
•
Tie Wraps (2 per leg)
•
Wire Nuts (blue or orange, 4 per bin)
•
Communication Wire (4 Cond. 20
– 22 AWG, shielded)
Steps to Come
There are several steps to install the BinTrac Dual Breeder Control system. To give an overview of the installation
process, these steps are outlined below.
•
Mounting
the ‘A’ frame
•
Lifting the bin
•
Anchoring
the ‘A’ frame
•
Wiring the Smart Summing Box
•
Setting the Smart Summing Box bins
•
Wiring the Power Supply
•
Wiring the BinTrac Dual Breeder Control
Please read through the entire installation process before attempting to install a BinTrac Dual
Breeder Control System. If you have any questions, do not hesitate to contact HerdStar or a
certified dealer in your area.
