Henny Penny PFG-691, Техническое руководство

Страница: 125 / 184

Procedure - Model PFE-580, PFE-590, PFE-592, and PFG-690 (AP0802029 and later)
If you have a model PFG-690, PFG-692 AP0802028 & below, proceed to page 2 .
1.
Using a 3/8” socket, remove the 6 nuts around exterior of rear cover shown in figure 1 below.
2.
Lift up on the rear cover and pull out at the bottom to clear threaded studs (figure 2.).
Removing the top
shroud makes it easier to remove the rear cover, but is not necessary.
Figure 1 Figure 2
Rear Cover Top Shroud
Lid Counterweight Cable Inspection
DO NOT USE THE FRYER IF THE LID IS HARD TO RAISE & LOWER!
1.
Inspection 5
Rev A